Warming Up Time; Automatic Zero Set - tecnotest STARGAS Manuel D'utilisation

BEFORE THE TEST _______________________________________________________________________ STARGAS
4.2 -

Warming up Time

After selecting one of the available tests the message WARMING UP is
displayed indicating the analyser warm-up phase that can last up to
60 seconds.
4.3 -

Automatic Zero Set

The analyser starts automatically the zero setting showing the message
AUTOZERO.
At the end of this phase the analyser is ready to be used.
At every AUTOZERO the instrument automatically carries out a calibration of
the O value (according to the parameters it has memorised).
2
In case some calibration errors occur (for instance due to a exhausted
sensor) the message will be displayed O
If the drawback persists it is necessary to apply to the technical
assistance service.
26
SENSOR EXHAUSTED.
2
OPERATING INSTRUCTIONS