For Customers In Europe; Customer Service - Sony Rm-Vlz620T Mode D'emploi

Symptom
A consecutive procedure does not work
properly.

For customers in Europe

Customer Service

If you have any questions or problems concerning the RM-VLZ620T that are not covered
in this manual, please call the customer remote helpline. The number is mentioned in the
warranty card.
Remedy
 When you programme a consecutive procedure, make sure to follow the correct steps
(pages 24).
 Change the direction the RM-VLZ620T is aimed. If the problem persists, position the
programmed devices closer together.
 Remove any obstacles in the path between the RM-VLZ620T and the devices.
 Position the devices back to the way they were before you set a consecutive procedure.
 Some devices may not always be powered on by a consecutive procedure. This is
because the power of the device turns on and off alternately when receiving the power
on/off signal. In this case, check the operating device's power on/off status beforehand.
 If you change the manufacturer's code or teach a new signal on a button that has been
programmed for a consecutive procedure, the new signal will be transmitted when you
press the corresponding Device Select button.
 Some devices may not respond to the next signal immediately after the power-on signal.
In this case, you can insert an interval by the following means.
– Change the button order.
– Press the same Device Select button again. Each time you press the button, you can
insert an interval (page 26).
 The button has already learned a function. Clear the learned function (page 20).
 Check the status of the device and make sure that you have set the device properly to
receive signals.
1
GB