Locking The Controls (Hold Function) - Sony RM-VLZ620T Mode D'emploi

To clear a programmed procedure
1
Press and hold SET for more than 3 seconds.
The SET indicator lights up.
While keeping SET held down, press

Enter  - 8 - 1.
The SET indicator flashes three times.

Press and hold the programmed button you want
to reset for more than 3 seconds.
When the programmed procedure is cleared, the
SET indicator flashes three times and turns off.
If your device does not accept
consecutive remote control signals
If the device does not respond to the next signal
immediately after the power-on signal, you can insert
other signals or an interval by pressing the same
Device Select button.
For Example, if TV power-on and input select do not
work properly:
 Insert another device signal by pressing
TV    DVD    TV  
 Insert a 0.3 second interval between each signal by
pressing
TV    TV  
(Added signals are underlined.)
Notes
 If you interrupt the procedure at any point for over 10 seconds,
the setting mode ends.
Start again from the beginning.
 If you try to programme more than 16 steps, the setting mode
ends, and the 16 steps you have programmed are registered.
 If you change the manufacturer's code or teach a new signal on a
button that has been programmed for a consecutive procedure,
the new signal will be transmitted when you press the
corresponding Device Select button.

GB
Locking the Controls (Hold
Function)
.
To prevent accidental operation, you can lock all the
buttons with the Hold function.
It is recommended to use this function to prevent
children from misoperating devices such as air
conditioners.
SET/SET
indicator
