Sony RM-VLZ620T Mode D'emploi page 25

1
Press and hold SET for more than 3
seconds.
While keeping SET held down, press ,
then release both buttons.
The SET indicator
lights up.
2
Enter  - 8 - 1.
The SET indicator flashes three times to indicate
that the setting mode has been entered.
3 flashes
3
SET/SET
indicator
Device
Select
buttons
4
, 8, 1
SYSTEM
CONTROL
buttons
5
To cancel the process
Press and hold SET for more than 3 seconds. The
SET indicator turns off.
Press a SYSTEM CONTROL button or
Device Select button you want to
programme.
Programme a consecutive procedure.
With this example, press the buttons in sequence
as below*:
DVD
* The procedure may differ depending on your device.
Programme the correct procedure for your device.
Notes
 You can press any button other than the SET or SYSTEM
CONTROL buttons.
 You can skip the  button for Sony devices by using
automatic power-on control instead.
 If you have programmed an incorrect operation by mistake,
the setting is cancelled. Start from the beginning.
 If you press a Device Select button in a consecutive
procedure, the function already learned on the button will
not be programmed.
Press SET to complete the programming.
The SET indicator flashes three times and turns
off.
3 flashes
VIDEO1

GB