Sony RM-VLZ620T Mode D'emploi page 13

2
Press and hold SET for more than 3
seconds.
While keeping SET held down, press the
desired Device Select button, then release
both buttons.
The selected Device Select button lights up.
3
Enter the manufacturer's code (01454).
The SET indicator flashes three times, and the
indicators turn off.
3 flashes
To cancel the process
Press SET anytime.
Note
If the setting is incomplete, the SET indicator flashes once and
the indicators turn off. Start again from the beginning.
If you enter a manufacturer's code that is not listed in the
supplied "Manufacturer's Code List, " the setting will be cancelled.
The SET indicator
lights up.
To operate the device
1
Press the Device Select button for the device you
want to operate.
The Device Select button flashes.

Press  to turn on the device.

Press any button to control the device.
See "Table of Preset Functions" (page 32) for the
functions of buttons for each device.
If the RM-VLZ620T does not seem to be working
 First, try repeating the setup procedure using another
manufacturer's code (if listed for your device).
 Try setting the code number using the Search function (page
14).
 The remote control signals may be different for some devices
or functions. In this case, teach the remote control appropriate
signals to the RM-VLZ620T (page 18).
To clear a manufacturer's code setting
You can reset the code of any Device Select button to
its factory setting.
1
Press and hold SET for more than 3 seconds.
The SET indicator lights up.
While keeping SET held down, press

Enter  - 0 - .
The SET indicator flashes three times.

Press the Device Select button you want to reset.
The SET indicator flashes three times and the
indicators turn off.
To cancel the process, press SET anytime.
Notes
 When you reset a Device Select button, the learned function or
programmed consecutive procedure will also be cleared from
the button.
 To clear all the settings of the RM-VLZ620T, see page 27.
.
1
GB