1
Press and hold SET for more than 3
seconds.
While keeping SET held down, press ,
then release both buttons.
The SET indicator
lights up.
2
Enter - - .
The SET indicator flashes three times to indicate
that the setting mode has been entered.
3 flashes
3
Press the Device Select button you want to
change.
The SET indicator flashes three times, and the
indicators turn off.
3 flashes
To cancel the process
Press SET anytime.
To check which Device Select button is set
for a Sony device
Press in Step 3 above.
The Device Select buttons set for Sony devices will
flash in sequence.
Device Select buttons set for non-Sony devices will
not flash.
To set automatic power-on control again
Perform the same procedure as when you clear the
automatic power-on control.
Notes
If you set the manufacturer's code of a non-Sony device on a
Device Select button, you cannot set the automatic power-on
control on the button.
If you change to the code of a non-Sony device after setting
automatic power-on control, the control will be cleared.
If you attempt automatic power-on control for a non-Sony
device, the SET indicator will flash once and turn off (to
indicate that you cannot set this control).
If you teach a signal or program a consecutive procedure to a
Device Select button to which the automatic power-on control
is set, the control will not work. To activate the control, clear
the learned signal or programmed consecutive procedure from
the Device Select button.
11
GB