Sony RM-VLZ620T Mode D'emploi page 20

Tips for teaching accurately
 Do not move the remote control units during the
learning procedure.
 Use new batteries in both remote control units.
 Avoid performing the learning procedure in places
subject to direct sunlight, or strong fluorescent
light. (Noise may interfere with the learning
procedure.)
 The remote control detector area may differ
depending on each remote control unit. If the RM-
VLZ620T does not learn signals, try changing the
positions of the two remote control units.
 When you teach the signals of an interactive signal
exchange system remote control unit (supplied
with certain Sony's amplifiers) to the RM-
VLZ620T, the response signal of the main unit
may interfere with the learning of the RM-
VLZ620T. In such a case, move to a place where
the signals will not reach the main unit (e.g.,
another room).
To clear the learned function of a single
button
Example: To clear the learned function from
number button 1 in DVD mode
1
Press and hold SET for more than 3
seconds.
While keeping SET held down, press ,
then release both buttons.
The SET indicator
lights up.
2
Enter  - 0 - .
The SET indicator flashes three times to indicate
that the setting mode has been entered.
3 flashes
0
GB
3
Press the desired Device Select button.
The selected Device Select button lights up.
4
Press the learned button you want to reset.
When the learned function is cleared, the SET
indicator flashes three times and the indicators
turn off.
3 flashes
Note
To clear another function, repeat Steps 3 and 4.
5
Press SET to finish setting.
The SET indicator turns off.
To cancel the process
Press SET anytime.
To clear all the learned functions under a
specific device mode
Example: To clear all learned functions
under DVD mode
1
Press and hold SET for more than 3
seconds.
While keeping SET held down, press ,
then release both buttons.
The SET indicator
lights up.