Sony RM-VLZ620T Mode D'emploi page 19

5
Press the button on the RM-VLZ620T you
want to teach.
The SET indicator flashes with the button press.
(Learning function standby.)
flash
Note
Perform the next step within 30 seconds. Otherwise, the SET
indicator flashes once and the learning procedure returns to
Step 4.
6
Press the button on the original remote
control to transmit the signal to the
RM-VLZ620T.
During signal transfer, only the SET indicator
stays lit, and the Device Select button turns off.
After signal transfer is complete, the SET
indicator flashes three times, and the RM-
VLZ620T returns to the state in Step 4.
Remote
control of
device
3 flashes
Data transfer
completed
Note
If the SET indicator flashes only once, it indicates that
learning is incomplete. Repeat from Step 4 again.
7
Repeat Steps 4 to 6 to teach other new
functions.
8
Press SET to finish teaching.
The SET indicator turns off.
To cancel the process
Press SET anytime.
Notes
 If you teach a signal to a button, the learned function will
remain even after you set a manufacturer's code.
 You cannot teach a simultaneous button operation (for
example  + ) to the two buttons on the RM-VLZ620T at a
time.
In this case, teach the signal to a single button while pressing
two buttons on the original remote control at the same time.
To teach an air-conditioner's functions
If you adjust the setting of the air-conditioner
according to the season, reset the parameters of the
air conditioner's remote control (temperature, air
strength and direction, etc.), and teach the new
remote signals to the RM-VLZ620T.
When the power button on the remote control for an
air-conditioner, etc., toggles between power-on and
off with each press, the power-on/off operation may
not be learned correctly. In this case, teach the
power-on/off signals to two separate buttons on the
RM-VLZ620T.
1
Teach the power-on signal to a button (transmit
the power-on signal by pressing the power button
when the device is turned off).

Teach the power-off signal to another button
(transmit the power-off signal by pressing the
power button when the device is turned on).
The two learned buttons of the RM-VLZ620T now
control the power-on/off signals of the device
respectively.
Note
Devices such as air conditioners and heaters receiving an infrared
signal can be dangerous if misoperated. Be sure to place the RM-
VLZ620T out of the reach of small children or pets, and lock the
controls using the Hold function (page 26).
1
GB