Example: To teach the DVD input signal of
your amplifier to the DVD Device Select
button (when the DVD input can be selected
with one button press)
1
Place the RM-VLZ620T head to head with
your device's remote control.
Remote control for
your device
About 3 – 8 cm
away
Note
If you do not perform learning steps within 10 seconds at any
point during the process, learning mode is cancelled.
2
Press and hold SET for more than 3
seconds.
While keeping SET held down, press ,
then release both buttons.
The SET indicator
lights up.
3
Enter - 8 - 8.
The SET indicator flashes three times to indicate
that the setting mode has been entered.
3 flashes
4
Press and hold the Device Select button you
want to teach for more than 3 seconds.
The selected Device Select button lights up.
GB
RM-VLZ620T
Notes
When teaching a SYSTEM CONTROL button, use a short
press. Note that the selected button does not light up.
If you do not perform the next step within 30 seconds, the
SET indicator flashes once. Repeat from Step 4 again.
5
Select the DVD input on the original
remote control.
After data transfer is complete, the SET indicator
flashes three times, and the RM-VLZ620T returns
to the state in Step 4.
3 flashes
Note
If the SET indicator flashes only once, it indicates that
learning is incomplete. Repeat from Step 4 again.
6
Repeat Steps 4 and 5 to teach other
functions.
7
Press SET to finish teaching.
The SET indicator turns off.
To cancel the process
Press SET anytime.
To clear the learned function from the
Device Select button or SYSTEM
CONTROL button
1
Press and hold SET for more than 3 seconds.
The SET indicator lights up.
While keeping SET held down, press
Enter - 0 - .
The SET indicator flashes three times.
Press and hold the Device Select button for more
than 3 seconds, or press the SYSTEM CONTROL
button you want to reset.
When the learned function is cleared, the SET
indicator flashes three times.
Press SET to finish setting.
The SET indicator turns off.
.