Preliminary Tasks On The Indoor Installation; Laying The Supply Line; Providing Fuse Protection - Mennekes AMTRON Manuel D'utilisation Et Guide D'installation

Masquer les pouces Voir aussi pour AMTRON:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 111
5.3 Preliminary tasks on the indoor
installation
T
T
DANGER
Fire hazard due to device overload.
There is a fire hazard due to overloading of the device
caused by unsuitable circuit breaker and supply line.
f Configure the circuit breaker and the supply line accor-
ding to the technical data of the device.
Î "4 Technical data"
The installation of a device in a supply grid in the
disturbance sources e.g. a frequency converter
can cause malfunction or termination of the char-
ging process.

5.3.1 Laying the supply line

f Configure the supply line according to the technical
data of the device.
Î "4 Technical data"
When dimensioning the supply line (cross sec-
tion and cable type), always ensure the following
local conditions:
„ Type of installation
„ Cable parameters per unit length
„ Line length
f Lay out the supply line to the desired location. The
device can be mounted on a wall or an stainless steel
or concrete column from MENNEKES.
Wall installation - surface installation
MENNEKES recommends fitting the device on a
customer-provided cable duct
(height 30 mm x width 45 mm).
For a surface installation, the pre-punched aperture on
the lower part of the underpart of the enclosure must be
broken out.
Wall installation - concealed installation
For concealed installation the position of the supply line
must be arranged using the provided drilling template or
Fig. "Fig. 10: Drilling dimensions [mm]".
Mounting on a stainless steel or concrete column
If need be the device can be mounted on a stainless steel
or concrete column.
The stainless steel or concrete columns are available from
MENNEKES as accessories.
Installation manual for the stainless steel or concrete

column.

5.3.2 Providing fuse protection

Depending on the version, the device is equipped with
a type A residual current device, a circuit breaker and a
relay for connection of an external shunt release
according to the table below.
Circuit breaker
Type A residual current device
Relay for shunt release
EN
-
x
x
-
x
x
x
-
-
13

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières