Mennekes AMTRON Manuel D'utilisation Et Guide D'installation page 62

Preparing until state
C (OCPP 1.6)
Allow long get confi-
guration keys
Block 4: Charging settings
Parameters
Free charging
Rfid Tag for Free Charging with
OCPP Full, fixed rfid modes
If in doubt allow charging
Block 5: Charging current
Parameters
Operator Current Limit (A)
Block 6: Load management
Parameters
Dynamic Load Management
Block 7: Load management
Parameters
Peer group Partner (deprecated)
Peer Group maximum current (A) (deprecated)
Peer Group Force Charging (deprecated)
24
Setting that specifies the conditions
under which the charging point
changes to the "Charging" state
Setting that specifies whether OCPP
keys are allowed to contain more
than 500 characters
Description
Charging without authorisation Charging
process begins as soon as a vehicle is
plugged in
RFID UID for the mode "Full fixed Rfid"
Emergency charging if there is no connec-
tion to the Backend-System
Description
Maximum charging current
Description
Backend sys-
tem
Not relevant for the device
Description
Not relevant for the device
Not relevant for the device
Not relevant for the device
„ Only for "OCPP-S 1.6" and
OCPP-J 1.6"
„ "On": Charging when the vehicle is
in C status
„ "Off": Charging when the vehicle is
in status B or C
Necessary for ... Remark
Authorisation
Necessary for ... Remark
Charging sys-
tem
Necessary for ... Remark
Necessary for ... Remark