Operation; Authorization - Mennekes AMTRON Manuel D'utilisation Et Guide D'installation

4
Fig. 17: Closing the device
f Lift the front panel (1) upwards and secure it with the
screws (2).
f Fit the upper part of the enclosure (3) and secure it
with the screws (4) and (5). Use supplied shortened
Allen key.
Screw
(2)
(4)
(5)
3
2
2
5
1
Torque
0.5 Nm
1.2 Nm
1.2 Nm

7 Operation

7.1

Authorization

Depending on the configuration, using the device
may require prior authorisation The following
possibilities exist:
„ No authorisation is required. All users can charge.
„ Authorisation through RFID.
„ All users with an RFID card can charge.
„ All users whose RFID card is activated can charge.
„ Authorisation through Backend-System.
„ Authorisation is dependent on a Backend-System,
for example with an RFID card, a smartphone app
or ad hoc (e.g. direct payment).
„ For version Professional+ 7,4 / 22 PnC only:
Authorisation by communication between device
and vehicle according to ISO 15118.
Requirement: support your vehicle and backend
system (ISO 15118).
The "Standby" symbol lights up on the LED information
9
panel.
f Authorising depending on the configuration:
f Authorisation through RFID: Hold the RFID card in
front of the RFID card reader.
f Authorisation through Backend-System: Follow the
instructions for the respective Backend-System.
f Authorisation according to ISO 15118: Connect the
charging cable to the vehicle and, if necessary, to
the device.
f Comply with the instructions on the device (e.g. scan
QR code).
The data are checked. The "Wait time" symbol lights up
9
on the LED information panel.
9 The authorisation was successful. The charging pro-
cess can now be started.
If charging does not start within the release time,
the authorisation is reset, the charging sockets
are locked and the device switches to "Standby"
mode. A new authorisation is required.
EN
29