Mennekes AMTRON Manuel D'utilisation Et Guide D'installation page 60

USB Additional fixed Gateway
Public address of the
ChargePoint
Mode for selecting the public
address of the ChargePoint
WAN router password
SSL Strictness as client
SOAP OCPP Server Port of
ChargePoint (Standard OCPP)
SSL mode as server
Backend connection timeout
Display backend disconnect as
error
Block 3: Authorisation, Backend-System
Parameters
OCPP Mode
Backend Whitelist
(SOAP)
Hostname (Binary
OCPP)
Portnumber (Binary
OCPP)
WebSockets JSON
OCPP URL of the
Backend
Tcp Watchdog
Timeout
22
Public IP address of the ChargePoint
Mode for the selection type of the public IP
addresses of the charging point
SSL-authentication as client
TCP server-port for the incoming connec-
tions from the Backend-System
SSL function and authentication as server
Time until an error message is displayed,
after the connection to the Backend-
System has been interrupted or could not
be restored
Setting that specifies, whether the error
"Backend disconnected" will be displayed.
Description
Selection of the OCPP communica-
tion protocol
List of the IP addresses that are allo-
wed to send requests to the device
WS / WSS-URL of the OCPP
Backend-Systems
Time until a restart will be exe-
cuted, after the connection to the
Backend-System has been inter-
rupted or could not be restored
Not relevant for the device
Backend
system
Not relevant for the device
Backend
system
Charging
system
Necessary Remark
for ...
Backend sys-
Only for "OCPP-S 1.5" and OCPP-S 1.6"
tem
Not relevant for the device
Not relevant for the device
„ Only for "OCPP-J 1.6".
Backend sys- „ ID of the charging point is automa-
tem tically attached when connecting to
the Backend-System
The value "0" prevents a restart of the
Charging sys- device
tem
Information will be provi-
ded from your
Backend-System ope-
rator
Only relevant, if "Display
backend disconnect as
error" = "On"
If this error is displayed
the "Fault" LED on the
device is flashing