Mennekes AMTRON Manuel D'utilisation Et Guide D'installation page 61

Enable cache Setting that specifies whether an
internal cache will be used for the
RFID-UID
List of entries in Listing of the RFID-UIDs present in
cache the internal cache
Cache expiry mode The expiration date of cache ent-
ries, if the OCPP expiration date has
not been specified by the Backend-
System
Local fixed authoriza- Setting that specifies whether a
tion list local authorisation list will be used
for the RFID-UIDs
List of entries in fixed Listing of the RFID-UIDs in the local
local list (FLL) authorisation list
RFID Tag letter case Setting that specifies how the RFID-
UIDs will be processed by the tag
management
Send Authorize for Setting that specifies whether after
RemoteStart receipt of an OCPP RemoteStart
request, an OCPP authorisati-
on message will be sent to the
Backend-System
Stop Transaction Setting that specifies how the
Mode device should behave at the end of
a transaction
Restart transaction Setting that specifies whether a
after power loss transaction will be continued after a
power outage
Send informative Setting that specifies whether infor-
StatusNotifications mative OCPP status messages will
be sent to the Backend-System
Send error Setting that specifies whether error-
StatusNotifications related OCPP status messages will
be sent to the Backend-System
Send USB error
StatusNotification
Strategy for Setting that specifies the conditions
StatusNotification under which the charging point
state transitions changes to the "Occupied" state
"Off": RFIDs will not be added to the
internal cache
„ Syntax: UID1:UID2:UID3 ...
„ Max. 80 RFID-UIDs
Preset: 2038 (latest permissible time)
Authorisation
„ Syntax: UID1:UID2:UID3 ...
„ Max. 80 RFID-UIDs
Information will be provided from your
Backend sys-
Backend-System operator
tem
"Normal" unlocks and ends the trans-
action, if the plug on the vehicle has
been unplugged (set for devices with
a permanently connected charging
Charging sys-
cable)
tem
For example, temperature reports
Backend sys-
tem
Not relevant for the device
„ Only for "OCPP-S 1.5"
„ "Occupied on Charging": Occupied
when an authorisation is present
Backend sys- and a charging cable is plugged in
tem „ "Occupied on Authorized/Plugged":
Occupied when the charging point
is authorised or a charging cable /
vehicle is connected
EN
23