Installing The Charger Station On The Wall - Mennekes AMTRON Start Instructions D'installation

5.4.3 Installing the charger station on the wall

For installation on concrete, brick and wood walls, use
the included installation hardware.
For other surfaces, a suitable on-site mounting method must
be chosen.
MENNEKES recommends the installation of the charging
station at a height (up to the top edge of the enclosure) of
approximately 1.50 metres above the finished floor.
 See also "Fig. 13: Wall mounting" on page 12.
1. Mark the mounting holes using the supplied drilling jig
and a spirit level.
2. Drill the holes in the wall with the diameter specified for
the selected installation hardware.
Wechs el ein- auf z weis paltig
Fig. 13: Wall mounting
Marking
A
Cable duct (for supply cable from above)
1
2 Cable duct (for supply cable from below)
3 Drilling jig
Wechs el ein- auf z weis paltig
3. Route the supply cable and possibly the data and control
cables to the positions specified on the frilling jig. A cable
of approx. 40 cm cable is needed for the electrical
connection inside the charging station.
4. Open the charging station (see Chapter 5.3 "Opening
the charging station" on page 11).
5. Run the supply cable and possibly the data and control
cables through the cable glands into the charging
station.
6. Secure the charging station to the wall by using dowels
and screws.
7. Check the charger for firm and secure fit.
Installation
B
Dowels
4
5 Screw
6 Plug (touch guard)
12