Scrapping - Nilfisk SW4000 Instructions D'utilisation

ENGLISH
TROUBLESHOOTING (Continues)
Trouble
The side brooms do not operate.
The machine collects little debris/dust.
The hopper does not lift.
The hopper does not dump.
The hopper does not lower.
The filter shaker does not work.
The dust guard system (optional) does not
work.
(*) For the relevant instructions, see also to the Engine Manual.
(**) Procedure to be performed by Nilfisk Service Center.
For further information contact a Nilfisk Service Center, where it is possible to consult the Service Manual.

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Batteries
– Polyester dust filter
– Main and side brooms
– Hydraulic system oil
– Hydraulic system oil filter
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Nilfisk Center especially when scrapping electrical and electronic components.
36
INSTRUCTIONS FOR USE
Possible cause
The FR1 or FR2 circuit breaker of the side
brooms is open.
The dust filter is clogged.
The hopper is full.
The skirts are not properly adjusted or are
broken.
The brooms are not properly adjusted.
The F1 fuse is open.
The hydraulic system oil level is incorrect.
The F6 fuse is open.
The hopper is too low.
In case of low temperatures, the hydraulic
system oil is slow in flowing through the safety
valve.
The F2 fuse is open.
The filter shaker is disconnected.
The water tank is empty.
The nozzles or the water filter are clogged.
The pump is faulty.
The F5 fuse is open.
SW4000, FLOORTEC R 870 - 1464815000
Remedy
Wait for the side broom motor to cool down,
then reset the fuse by pressing the relevant
push-button.
Clean the dust filter by using the filter shaker
or by disassembling it.
Empty the hopper.
Adjust/replace the skirts.
Adjust the broom height.
Replace the fuse.
Check the hydraulic system oil level in the
tank.
Replace the fuse.
Lift the hopper at a minimum height of 350
mm.
Wait a few moments to let the hydraulic
system oil flow.
Replace the fuse.
Connect the filter shaker connector.
Fill the tank.
Clean.
Replace. (**)
Replace the fuse.
03/2013