Engine Oil Level Check; Engine Oil Change - Nilfisk SW4000 Instructions D'utilisation

ENGINE OIL LEVEL CHECK

CAUTION!
Running the engine with a low oil level can
damage the engine itself.
NOTE
The oil alert system will automatically stop the engine
before the oil level goes down under the safety limit.
To avoid a sudden engine stop, always check the oil
level before each start-up.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (61) to "0".
3. Open the engine compartment hood (18) with the handle
(41) and fasten it with the support rod (53).
4. Lift and disassemble the right side bulkhead (45).
5. Remove the oil filler plug/dipstick (A, Fig. 22) and clean it.
6. Insert the oil filler plug/dipstick in the filler neck (B), but do
not tighten it, then remove it to check the oil level.
7. If the oil level is near or under the lower limit mark (C) on
the dipstick, top up with the specified oil up to the upper
limit mark (D) (lower edge of the oil filling hose). Do not
overfill.
8. Install the oil filler plug/dipstick (A).

ENGINE OIL CHANGE

CAUTION!
The discharged engine oil must be disposed of
properly according to the Law in force.
NOTE
It is advisable to change the oil when the engine is
still hot, to make the oil downflow easier.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (61) to "0".
3. Open the engine compartment hood (18) with the handle
(41) and fasten it with the support rod (53).
4. Lift and disassemble the right side bulkhead (45).
5. Remove the oil filler plug/dipstick (A, Fig. 22), place the
hose (E) in a position that eases the oil drain, then remove
the plug (F).
6. Remove the oil drain plug (F) from the hose and drain the
oil into a suitable container, then install the oil drain plug
and hose.
7. Pour new oil in the filler neck (B) up to the upper limit mark
(D) (lower edge of the oil filling hose) on the dipstick.
NOTE
As for engine oil type and quantity, see the Technical
Data chapter and the Engine Manual.
8. Install the oil filler plug/dipstick (A) and tighten it.
03/2013
INSTRUCTIONS FOR USE
F
E
A
1464815000 - SW4000, FLOORTEC R 870
A
B
D
C
Figure 22
ENGLISH
P100616
31