Maintenance; Scheduled Maintenance Table - Nilfisk SW4000 Instructions D'utilisation

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
WARNING!
To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, the
batteries must be disconnected.
Read carefully the instructions in the Safety chapter before performing any maintenance procedure.

SCHEDULED MAINTENANCE TABLE

Procedure
Engine oil level check
Battery fluid level check
Side and main broom height check
Engine air filter check
Brake cable check and adjustment
Hopper dust filter check and cleaning ("A" method)
Hopper hydraulic lifting system oil level check
Skirt height and operation check
Dust guard system water filter check and cleaning (optional)
Engine air filter cleaning
Hopper dust filter check and cleaning ("B" method)
Filter shaker operation check
Main broom driving belt visual inspection
Engine oil change
Spark plug check/cleaning
Steering chain cleaning
Safety system operation check
Engine filter trap cleaning
Engine baffle plate cleaning
Fuel filter cleaning
Brake pad check/adjustment/replacement
20
INSTRUCTIONS FOR USE
SW4000, FLOORTEC R 870 - 1464815000
Upon Every 10 Every 50
delivery hours hours
(1)
(2)
(1)
(3)
(4)
(2)
(4)
Every Every
Every
100 200
year
hours hours
(4)
(4)
(*)
(*)
(5) (6)
(*)
(2)
(7)
(*)(3)
03/2013