Télécharger Imprimer la page

Safety Functions And Troubleshooting; Hood Safety Switch; Scrapping - Nilfisk Advance Terra 128B Mode D'emploi Et D'entretien

Publicité

Les langues disponibles

Les langues disponibles

OPERATOR MANUAL
NOTE:
When the battery charger is connected to
the electrical supply, all machine func-
tions are automatically shut off.
SAFETY FUNCTIONS AND
TROUBLESHOOTING

HOOD SAFETY SWITCH

It is activated when the machine hood is lifted up: it
stops all machine functions.
In the case where the machine starts even when the
hood is open, contact an authorized Service Center or
Retailer for Service.
TROUBLESHOOTING
TROUBLE
When the key is in the "I"
position, the machine does not
start.
The side broom does not
operate
The machine operates only
when stationary, otherwise the
red warning light turns on.
The circuit breaker (6, Fig. T)
trips frequently.
The battery run time is low.
12
SOLUTION
Check that the connector 3, Fig. T is
properly connected.
Check that the hood is properly
closed.
Check the circuit breaker (6, Fig. T)
Check the signal circuit fuse (18, Fig.
T) integrity
Check that the battery charger is
properly connected to the battery/ies
and/or the battery charger is not
plugged in to recharge the
battery/ies.
Check the side broom fuse (7, Fig. B)
integrity
Re-charge the battery. If the problem
persists, replace the battery.
Check if the main broom pattern is
not wider than 4 cm (1.57 in)
Check that the machine is not
working on slopes higher than 2%
Check if debris is not blocking the
main broom rotation
Install a battery with greater capacity.
(Min. 140Ah)
NOTE:
If your machine has a battery charger in-
stalled, the machine can not operate if the
charger is not on board. In case of battery
charger malfunction, contact an Autho-
rized Service Center.
For further information consult the Service Manual at
the Advance Service Center.

SCRAPPING

Have the machine scrapped by a qualified dismantler.
Before scrapping the machine, remove the following
components:
1.
Battery
2.
Polyester dust filter
3.
Main and side brooms.
4.
Circuit board
CAUTION!
The removed components must be dis-
posed of properly and according to all ap-
plicable laws.
146 0596 000(4)2004-02

Publicité

loading

Ce manuel est également adapté pour:

908 4003 010