Troubleshooting; Scrapping - Nilfisk Advance SW 700S P Manuel D'utilisation

ENGLISH

TROUBLESHOOTING

Trouble
The engine does not start when pulling the
handle.
The engine stops during operation.
The side broom does not operate.
When pulling the drive lever, the machine does
not move, or it moves slowly.
(1) For the relevant procedure, see the Petrol Engine Manual.
For further information, refer to the Service Manual, available at any Nilfi sk-Advance Service Center.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Polyester dust fi lter
– Main and side brooms
– Engine oil
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Nilfi sk-Advance Center especially when scrapping electrical and electronic components.
20
USER MANUAL
Possible cause
The ignition key is not turned to "I".
The engine oil level is low.
The fuel tap is closed.
The fuel tank is empty.
The hood is not properly closed.
The fuel does not reach the carburettor.
The spark plug does not produce a spark.
The engine oil level is low.
The fuel tank is empty.
The side broom is not lowered.
The side broom belt or belt tensioner is not
effi cient.
The pedal brake (optional) is engaged.
The driving belt tensioner is not operating.
The driving belt is not effi cient.
146 0676 000(5)2007-06 A
Remedy
Turn the ignition key to "I".
Add engine oil. (1)
Open the fuel tap.
Refuel.
Close the hood properly.
Check if the fuel reaches the carburettor. (1)
Clean/replace the spark plug. (1)
Add engine oil. (1)
Refuel.
Lower the side broom.
Contact an authorised Nilfi sk-Advance
Service Center.
Release the pedal brake (optional).
Contact an authorised Nilfi sk-Advance
Service Center.
Contact an authorised Nilfi sk-Advance
Service Center.
SW 700S P