Troubleshooting; Technical Specifi Cations - Nilfisk Advance FM810 ST Mode D'emploi

A - ENGLISH

TROUBLESHOOTING

Problem
Motor will not start.
Motor fails to start / runs sluggish.
Fuse / Circuit Breaker repeatedly trips.
TECHNICAL SPECIFICATIONS (as installed and tested on the unit)
Model
Model Number
Electrical
Pad/Brush Speed
Pad/Brush Size
Total Weight (w/cord)
Sound Pressure Level (ISO 11201)
Protection Grade
Protection Class
Material Composition and Recyclability
Type
Aluminum
Electrical / motors / engines - misc
Ferrous metals
Harnesses / cables
Liquids
Plastic - non-recyclable
Plastic - recyclable
Polyethylene
Rubber
A-10
INSTRUCTIONS FOR USE
Cause
No power.
Switch Lever Safety Lock Button (2) not
depressed
Defective switch / Faulty connection
Low voltage from excessive length or
undersized extension cord.
Defective start capacitor.
Defective start switch.
Defective start/run capacitor
Defective motor low voltage
Low voltage.
Bad connection.
Defective motor.
FM810 ST
56105614
1.5HP - 115V/60Hz
3540 rpm
14" x 20" (355mm x 508mm)
160.5 lbs. (72.8 kg)
% of machine weight
1%
38%
52%
6%
0%
2%
1%
0%
1%
FM810 ST, FM810 XP - 56091150
Action
Check power supply and connection
Depress Switch Lever Safety Lock Button (2)
before activating Switch Levers (3).
Contact an authorized Advance Dealer.
Use a 12 Ga extension cord, not to exceed
50' length.
Contact an authorized Advance Dealer.
Contact an authorized Advance Dealer.
Contact an authorized Advance Dealer.
Contact an authorized Advance Dealer.
Eliminate extension cord. Locate power
source closer to work site. Have voltage
checked by a qualifi ed electrician.
Contact an authorized Advance Dealer.
Contact an authorized Advance Dealer.
14" x 20" (355mm x 508mm)
69dBA
IPX0
% recyclable
100%
70%
100%
67%
0%
0%
100%
0%
100%
FM810 XP
56105616
1.5HP - 115V/60Hz
3540 rpm
171 lbs. (77.5 kg)
69dBA
IPX0
2/2015