Cautions And Warnings - Nilfisk Advance FM810 ST Mode D'emploi

CAUTIONS AND WARNINGS

SYMBOLS
Advance uses the symbols below to signal potentially dangerous conditions. Read this information carefully and take the necessary
steps to protect personnel and property.
DANGER!
Is used to warn of immediate hazards that will cause severe personal injury or death.
WARNING!
Is used to call attention to a situation that could cause severe personal injury.
CAUTION!
Is used to call attention to a situation that could cause minor personal injury or damage to the machine or other property.
Read all instructions before using.
GENERAL SAFETY INSTRUCTIONS
Specifi c Cautions and Warnings are included to warn you of potential danger of machine damage or bodily harm.
DANGER!
* Failure to read the Owner's Manual prior to operating or servicing your Advance machine could result in injury to you or to other personnel;
damage to the machine or to other property could occur as well. You must have training in the operation of this machine before using it. If
you or your operator(s) cannot read English, have this manual explained fully before attempting to operate this machine.
* Sanding/fi nishing wood fl oors can create an explosive or combustible environment. Do not operate this machine around solvents, thinners,
alcohol, fuels, fl oor fi nishes, wood dust or any other fl ammable materials. Cigarette lighters, pilot lights, electrical sparks and all other
sources of ignition should be extinguished or avoided. Keep work area well ventilated.
* Dust generated from sanding wood fl oors can spontaneously ignite or explode. Promptly dispose of any sanding dust in a metal container
clear of any combustibles. Do not dispose in a fi re.
* Electrocution could occur if the machine is being serviced while the machine is connected to a power source. Disconnect the power supply
before servicing.
* Electrocution or fi re could occur if the machine is being operated with a damaged power cord. Keep the power cord clear of the pad. Always
lift the cord over the machine. Do not move the machine by the power cord.
* Shock hazard. Do not use the machine if it has been rained on or sprayed with water.
* To avoid injury keep hands, feet, and loose clothing away from all moving parts on the machine. Disconnect the power cord before replacing
the pad, changing the abrasive, or when servicing. Do not operate the machine unless all guards are in place. Never leave the machine
unattended while connected to a power source.
WARNING!
* Injury can occur if protective clothing or equipment is not used while sanding. Always wear safety goggles, protective clothing, and dust mask
while sanding.
* This sander is not to be used on pressure treated wood. Some pressure treated woods contain arsenic and sanding pressure treated wood
produces hazardous dust. Inhaling hazardous dust from pressure treated wood can cause serious injury or death. Sanding pressure treated
wood decks or uneven surfaces can damage the sander which is not covered under warranty or damage waiver.
* Any alterations or modifi cations of this machine could result in damage to the machine or injury to the operator or other bystanders.
Alterations or modifi cations not authorized by the manufacturer voids any and all warranties and liabilities.
2/2015
SAVE THESE INSTRUCTIONS
56091150 - FM810 ST, FM810 XP
INSTRUCTIONS FOR USE ENGLISH - A
A-3