Télécharger Imprimer la page

Troubleshooting; Scrapping - Nilfisk Advance SW 750 Manuel D'utilisation

Masquer les pouces Voir aussi pour Advance SW 750:

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH

TROUBLESHOOTING

Trouble
The machine does not start when turning the
main switch to "I" or to "II".
The side broom does not operate.
The machine operates only when stationary,
otherwise it turns off and the red warning
light fl ashes.
The battery autonomy is low.
The batteries do not charge: the red warning
light (4) does not turn on when the plug is
inserted in the electrical mains socket.
For further information, refer to the Service Manual, available at any Nilfi sk-Advance Service Center.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to
the Law in force:
Battery
Brooms
Plastic hoses and components
Electrical and electronic components (*)
(*)
Refer to the nearest Nilfi sk-Advance Center especially when scrapping electrical and electronic components.
18
USER MANUAL
Possible cause
There is an open in the fuse (21).
The battery charger cable is connected to
the electrical mains.
The batteries are discharged.
There is an open in the fuse (20).
The batteries are discharged.
The batteries are dead.
There is no power supply at the electrical
mains socket.
146 3080 000(1)2006-10 A
Remedy
Reset the fuse by pressing the relevant
button.
Disconnect it and place it in the housing.
Charge the batteries.
Reset the fuse by pressing the relevant
button.
Charge the batteries. If the trouble persists,
have the batteries replaced at Nilfi sk-
Advance Service Center.
Have the batteries replaced at Nilfi sk-
Advance Service Center.
Check the electrical mains socket by trying
to connect another domestic appliance.
SW 750

Publicité

loading