Use; Before Starting The Machine; Starting And Stopping The Machine - Nilfisk Advance SW 700S P Manuel D'utilisation

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
–
DANGER
–
WARNING
–
CAUTION
–
CONSULTATION
While reading this Manual, the operator must pay careful attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if they are damaged.

BEFORE STARTING THE MACHINE

1. Make sure that the debris container (17) is properly closed
before starting the machine.
2. If necessary, remove the cap (27) and refuel the machine.
CAUTION!
Do not fi ll the fuel tank beyond the upper limit
mark (A, Fig. 1).

STARTING AND STOPPING THE MACHINE

Starting the machine
1. Adjust the handlebar (3) with the knobs (5).
2. Ensure that the side broom (10) is lifted.
3. Open the fuel tap (A, Fig. 2) by introducing the hand into
the compartment (29) without opening the hood (7).
4. Turn the engine choke lever (A, Fig. 3) to closed position
(B) by introducing the hand into the compartment (29)
without opening the hood (7).
NOTE
Do not close the choke lever if the engine is hot and
if the air temperature is suffi ciently high.
5. Turn the ignition key (71) to "I".
6. Pull slowly the engine pull-start cord handle (28) until a
certain resistance is achieved; then pull suddenly and
strongly and start the engine.
CAUTION!
Do not allow the handle (28) to return strongly
but bring it back to its position slowly, to prevent
the starting system from being damaged.
CAUTION!
When starting the engine with the handle (28) do
not pull the drive lever (4).
10
USER MANUAL
146 0676 000(5)2007-06 A SW 700S P
Figure 1
Figure 2
Figure 3
S311480
S311481
S311482