Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
ENGLISH
AFTER USE
1
Lift the Operator Handle (6) until it locks in the upright position.
NOTE: The Safety Lock Button (2) will not depress unless the
Operator Handle (6) has been released and tilted back into the
operating position. This will prevent the motor from being engaged
while Operator Handle (6) is in the storage position.
2
Unplug the Power Cord (5) and wrap it around the Handle Release
Latch (4) and the right Operator Handle Grip (1).
3
Check the skirt around the dust control housing. The skirt should be
replaced if it is worn out or torn.
4
Remove the pad from the machine. Clean the pad and hang it up to
dry. Allow buffi ng pads to dry completely before using again.
5
Wipe the entire machine with a clean, damp cloth.
6
Inspect the entire machine and all accessories for damage. Perform
any required maintenance or repairs before storage.
7
Store the machine in a clean, dry place with the Operator Handle (6)
locked in the upright position.
MAINTENANCE
C - DUST COLLECTION BAG
The dust collection bag should be removed and replaced after about every
20 hours of use. Tip the machine back onto it's handle (6), the same as
you would if you were changing the pad. Squeeze in on the sides of the
bag cover "A" and remove it from the machine. Remove the dust bag "B"
(being careful not to spill any debris) and discard. Tip the machine back
upright. Push in on the sides of the new bag "B" to pop-it-open and install it
by pushing it down (grip the cardboard base of the bag) onto the (2) tubes
protruding from the base. Re-install the cover "A".
MOTOR BRUSHES
This machine is equipped with a motor brush wear indicator light. If this light
comes on during use, contact your local Advance distributor to have the
motor serviced.
NOTE: If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualifi ed person in order to
avoid a hazard.
CAUTION!
The motor can be severely damaged if the machine is used for an extended
period of time with the light glowing.
6 - FORM NO. 71279A - Advolution 20, 20XP
TROUBLESHOOTING
SWIRL MARKS
•
Floor not clean.
•
Area not properly swept - debris in pad or brush.
•
Improper pad for the job.
•
Moving the machine too fast.
CIRCLES ON THE FLOOR
•
Machine standing still while the pad is running.
FLOOR FINISH REMOVED
•
Improper pad...too aggressive.
•
Moving the machine too slowly.
MACHINE VIBRATES DURING OPERATION
•
Defective pad... one side is more dense than the other.
•
Machine left sitting on pad for extended period of time causing pad to
"take a set".
•
Pad not "seated" properly into pad holder bristles..
•
Pad not centered on pad holder periphery.
•
Pad not rated for RPM of high speed burnisher.
•
Defective pad driver. Remove pad, hold machine up off of fl oor with
handle and start machine. If machine vibrates, replace pad driver.
MACHINE DOES NOT RUN
•
Check plug for proper connection - on machine and at wall outlet.
•
Check building circuit breaker.
•
Call for service.
MACHINE STALLS OR TRIPS BREAKERS
•
Adjust wheel height to lower the average amperage in the application
to a range between 9-13 amps. See Detail 1 below.
•
Call for service if required.
Detail 1
Move wheel up to
increase amps.
Neutral wheel position
Move wheel down to
decrease amps.
revised 1/2018
Publicité
Table des Matières
