Troubleshooting; Scrapping - Nilfisk CA 430 S Manuel D'emploi Et D'entretien

TROUBLESHOOTING

TROUBLE
Motors do not work
Insufficient dirty water
vacuuming
Insufficient solution flow to the
brush
Scoring caused by the
squeegee
08812944(2)2004-05 A
CAUSE
The electric supply plug (22, Fig. C)
is not correctly connected
The electric supply cable (23, Fig.
C) is not correctly connected
The recovery tank is full (5, Fig. G)
Closed obstructed vacuum grid (8,
Fig. G) or stuck float
Hose disconnected (25, Fig. C)
from the squeegee
Dirty squeegee or worn/damaged
squeegee rubbers
Incorrectly closed tank cover, or
damaged gasket (7, Fig. E) or
obstructed compensation hole (11,
Fig. E)
Dirty solution filter (2, Fig. F)
Dirty tank (6, Fig. G) (obstructed
output hole)
Debris under the squeegee rubbers
Worn, chipped or torn squeegee
rubbers
Squeegee not balanced with knob
(12, Fig. C)
USE AND MAINTENANCE MANUAL

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, always remove the
following components:
a) Brush
b) Pad
c) Electric motors
d) Electronic board
CAUTION!
The removed components must be
disposed according to the Law in force.
11