Troubleshooting; Scrapping - Nilfisk ALTO SCRUBTEC 653E Manuel D'utilisation

ENGLISH

TROUBLESHOOTING

Trouble
The motors do not operate.
The recovery water vacuuming is insuffi cient.
The solution fl ow to the brushes is insuffi cient.
The squeegee leaves marks on the fl oor.
For further information refer to the Service Manual, available at any Nilfi sk Alto Service Center.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Brushes/pads
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Nilfi sk Alto Center especially when scrapping electrical and electronic components.
18
USER MANUAL
The power supply cable or the relevant plug
is broken.
The recovery tank is full.
The hose is disconnected from the squeegee. Connect.
The vacuum grid is clogged or the fl oat is
stuck closed.
The squeegee is dirty or the squeegee blades
are worn or damaged.
The tank cover is not properly closed or the
gasket is damaged.
The solution fi lter is dirty.
The tank is dirty (the drain hole is clogged).
There are debris under the squeegee blades.
The squeegee blades are worn, chipped or
torn.
The squeegee has not been adjusted with the
handwheel.
SCRUBTEC 653E
Possible Cause Remedy
Replace the cable.
Empty the tank.
Clean the grid or check the fl oat.
Clean and check the squeegee.
Close the cover or clean/replace the gasket.
Clean the fi lter.
Clean the tank.
Remove the debris.
Replace the blades.
Adjust it.
9097060000(2)2009-10 A