Use; Before Machine Start-Up - Nilfisk ALTO SCRUBTEC 653E Manuel D'utilisation

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
–
DANGER
–
WARNING
–
CAUTION
–
CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.

BEFORE MACHINE START-UP

Brush/pad-holder installation/removal
1. Place the brush (A, Fig. 1) or the pad-holder (B) under the deck (14).
2. Lower the deck on the brush/pad-holder by pressing the pedal (8).
3. Connect the power supply cable (3) to the electrical mains.
4. Engage the brush or pad-holder by pressing the switch (51) for a few seconds.
5. Press one of the switches (55) to engage the brush or the pad-holder.
WARNING!
Do not press the switches (55) too much, otherwise the machine will start.
6. To remove the brush/pad-holder lift the deck by pressing the pedal (8), then manually remove the brush/pad-holder from the
hub, by turning it in the opposite direction to the normal rotation direction.
Types of brushes available
530 mm-models
PROLENE
MIDLITE GRIT 180
MIDGRIT 240
PROLITE
UNION MIX
10
USER MANUAL
SCRUBTEC 653E
Figure 1
S311334
9097060000(2)2009-10 A