Guarantee; Possible Faults; Spare Parts - ATIKA DKV 400 Instructions D'utilisation

Guarantee

We grant a guarantee of two years, commencing with the day of
delivery from the dealer's store, for material and manufacturing
faults.
Warranty claims, even during the warranty period, will not be
accepted for damages due to incorrect handling or inadequate
packaging during return of the devices or to a non-observance
of the operating instructions.

Possible faults

Fault
After switching on, the
machine does not start or
switches off automatically.
Machine stops while cutting
Work piece jams when
pushing forward or pulling
back
Burn marks at the cut edges • Saw blade is unsuitable for the cutting
Chip exit blocked

Spare parts

Pos. Name
1 On / Off switch
18 Table insert
Service: Tel. 0 23 82 / 8 92 - 58
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Saw blade blunt
• Saw blade blunt
task or blunt
• No exhaust suction connected
• Suction too weak
Spare parts no.
362890
362892
- 65
Faulty parts must be sent to our works, postage or freight free.
We reserve the right to decide upon free spare part delivery.
Guarantee work will be completed by us or an authorised
servicing agency. Guarantee damage can only be remedied by
another firm with our explicit approval.
The guarantee does not cover normal wear to: Saw blade, saw
blade protection, table insert.
Guarantee is also granted if original spare parts are used.
Subject to changes in the interest of technical progress.
Removal (disconnect power plug)
• Replace fuse
• Check cable, no longer use defect cable
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Replace saw blade
• Hold the workpiece firmly and switch the motor off
immediately. After this renew saw blade.
• Exchange saw blade
• Switch off saw and remove chips
• See "Safe working"
Pos. Name
8 Saw blade protection
Without fig. Ersatzblätter
20
Spare parts no.
362891
362893