Amann Girrbach argovent 2 Mode D'emploi page 32

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
A P P L I C A T I O N A N D O P E R A T I O N
NOTE:
E N
Possible adhering/bonding of sintering cover
and sintering bowl!
When using for the first time, the powder is still
very sinter-active and would bond the sintering
cover and sintering bowl together.
▷ Do not mix in powder.
The powder may not be mixed in until after the
first two sintering runs.
7.2
Sintering
▷ Place the Sintron remainder/test crown cen-
trally onto sprinkled on pearls.
NOTE:
Danger of breakage of sintering bowl/cover!
When the bed of pearls is not loosened up, the
pressure on the sintering bowl/cover increases.
▷ To loosen up the bed of pearls: Insert the sinter-
ing cover [3] and apply a few twisting motions
until the cover abuts the floor.
Fig. 22
▷ Place sintering capsule manually or with the
supplied tongs into the furnace at the centre of
the sintering base.
32
▷ Place protective-gas retort over the sintering
capsule onto the sintering base.
Fig. 23
The retort weight ensures the optimal sin-
tering result in the Argovent 2.
▷ Because of the high weight: When using
the tongs, support the retort weight
manually or with additional tongs from
below until placed on the retort.
▷ Position the retort weight onto the protective-
gas retort.
3
5
Fig. 24
2
1

Publicité

Table des Matières
loading

Table des Matières