Amann Girrbach argovent 2 Mode D'emploi page 27

If connecting the Argovent 2 fails:
▷ Remove the sintering base.
▷ Outside of the furnace, hold the sinter-
ing base by the connection pin and care-
fully mount the gas hose onto the hose
piece of the sintering base.
This slightly expands the seal and makes
connecting the Argovent in the furnace
easier.
▷ Undo the connection again, place the
sintering base into the furnace and re-
establish the connection.
▷ Mount the back panel of the furnace and screw
in the six screws.
Fig. 10
I N S T A L L A T I O N
▷ Mount the insulating stone, ensuring that the
ceramic studs engage into the holes in front of
the floor plate.
Fig. 11
To check if the insulating stone is properly seated:
▷ Carefully close the furnace lift door.
▷ Insert mains plug again.
E N
27