Clean The Water Collection Tray (Fig. 17); Clean Specific Materials; Clean The Stainless Steel - Arneg Bergen 2 Manuel D'installation Et De Service

DO NOT touch/crush the probes
DO NOT fold or damage the capacitor blades

22.6 Clean the water collection tray (Fig. 17)

The collection tray can be removed for cleaning
Remove the tray and clean - see "General indications" and "Cleaning the internal parts".
i
Should you notice ice built up, call a specialized technician.

22.7 Clean specific materials

Material
Glass • use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• Immediately remove all traces of
water and detergent with a dry
cloth in order to prevent marks
from forming and to prevent liquid
from reaching the gaskets, frame,
or the glass door hinges.
• use a cloth soaked in neutral deter-
Plastic
gent
(door seal
• clean with a cloth soaked in clean
profiles)
water
Aluminium • use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• Immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming.
Wood • use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• Immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming.
• If necessary, before treating the en-
tire surface, test on a small hidden
area and verify that the cleaner will
not damage the finish or colour

22.8 Clean the stainless steel

Certain situations can cause the formation of rust on the surfaces in steel, such as:
iron remains left on damp surfaces, limestone, chlorine or ammonia based detergents not rinsed
properly, food incrustations or residues, salt-saline solutions, dry residues of evaporated liquids
05060176 00 11-09-2018
Remedy What to avoid
DO NOT use hot water on cold glass surfaces;
the glass could crack and injure the operator
DO NOT use rough or abrasive materials or
metal scrapers that could scratch the glass
surfaces
DO NOT use dirty cloths
gently place them on a flat surface, DO NOT
break or damage them
DO NOT use waxes, concentrated detergents,
which contain oil, bleach, glass cleaners, abra-
sive detergents or flammable fluids
DO NOT use acid or alkaline detergents (e.g.
bleach) which could corrode the surfaces
DO NOT use rough or abrasive materials or
metal scrapers that scratch the aluminium
surfaces
DO NOT use steam cleaning equipment
DO NOT use dirty cloths
DO NOT use spray cans, acid or alkaline de-
tergents (e.g. bleach), soda or solvents which
could corrode the surfaces
DO NOT use rough or abrasive materials that
could scratch the surfaces
DO NOT use steam cleaning equipment
DO NOT use rough cloths
moderate the use of liquid detergent: overuse
causes seepage and then swelling of the wood
Bergen 2
English
41