Daikin RoCon+ HP1 ETSH16P30D Manuel D'utilisation page 453

Meny: Access
Meny: System
Min. mixer valve pump System
Max. mixer valve pump
Ill. 100-6 Parametre i menyen "System"
Meny: Sensors
Outside temperature sensor
Outside temperature correction
Ill. 100-7 Parametre i menyen "Sensors"
Meny: HC config
Weather-compensated
Frost protection temperature
Building insulation
Ill. 100-8 Parametre i menyen "HC config"
Meny: Heating
Heat limit, heating mode
Heat limit, reducing mode
Heating curve
Feed temperature, heating mode
Feed temperature, reducing mode
Max. feed temperature
Min. feed temperature
Room influence
Room sensor adaptation
Heating curve adaptation
SlopeOffset
Ill. 100-9 Parametre i menyen "Heating"
Meny: Cooling
Cooling curve
Cooling parameters
Ill. 100-10 Parametre i menyen "Cooling"
Meny: Special
Relay test
Screed
Program
Ill. 100-11 Parametre i menyen "Special"
Daikin RoCon+ HP
Daikin Regulering RoCon+ HP1
008.1447899_00 – 09/2019 – NO
Target flow cooling, start
Target flow cooling, max.
Start cooling outside temp.
Max. cooling outside temp.
Feed temperature lower limit
Feed temperature, cooling mode
Cooling setpoint correction
Screed drying
Screed program
Meny: Information
Values
Ill. 100-12 Parametre i menyen "Information"
9 Blandemodul
Average outside temperature
Mixer temperature, current
Mixer temperature, target
Mixer pump status
PWM mixer pump
Mixer valve status
Software no. B1/U1
Mixer software number
Brukerveiledning
453