Daikin RoCon+ HP1 ETSH16P30D Manuel D'utilisation page 344

9 Blandermodul
Menu: Access
Menu: System
Min. mixer valve pump System
Max. mixer valve pump
Bill. 74-6 Parameter i menu "System"
Menu: Sensors
Outside temperature sensor
Outside temperature correction
Bill. 74-7 Parameter i menu "Sensors"
Menu: HC config
Weather-compensated
Frost protection temperature
Building insulation
Bill. 74-8 Parameter i menu "HC config"
Menu: Heating
Heat limit, heating mode
Heat limit, reducing mode
Heating curve
Feed temperature, heating mode
Feed temperature, reducing mode
Max. feed temperature
Min. feed temperature
Room influence
Room sensor adaptation
Heating curve adaptation
SlopeOffset
Bill. 74-9 Parameter i menu "Heating"
Menu: Cooling
Cooling curve
Cooling parameters
Bill. 74-10 Parameter i menu "Cooling"
Menu: Special
Relay test
Screed
Program
Bill. 74-11 Parameter i menu "Special"
Driftsvejledning
344
Target flow cooling, start
Target flow cooling, max.
Start cooling outside temp.
Max. cooling outside temp.
Feed temperature lower limit
Feed temperature, cooling mode
Cooling setpoint correction
Screed drying
Screed program
Menu: Information
Values
Bill. 74-12 Parameter i menu "Information"
Average outside temperature
Mixer temperature, current
Mixer temperature, target
Mixer pump status
PWM mixer pump
Mixer valve status
Software no. B1/U1
Mixer software number
Daikin RoCon+ HP
Daikin regulering RoCon+ HP1
008.1447899_00 – 09/2019 – DA