Daikin RoCon+ HP1 ETSH16P30D Manuel D'utilisation page 509

Valikko: Access
Valikko: System
Min. mixer valve pump System
Max. mixer valve pump
Kuva 113-6 Valikon "System" parametrit
Valikko: Sensors
Outside temperature sensor
Outside temperature correction
Kuva 113-7 Valikon "Sensors" parametrit
Valikko: HC config
Weather-compensated
Frost protection temperature
Building insulation
Kuva 113-8 Valikon "HC config" parametrit
Valikko: Heating
Heat limit, heating mode
Heat limit, reducing mode
Heating curve
Feed temperature, heating mode
Feed temperature, reducing mode
Max. feed temperature
Min. feed temperature
Room influence
Room sensor adaptation
Heating curve adaptation
SlopeOffset
Kuva 113-9 Valikon "Heating" parametrit
Valikko: Cooling
Cooling curve
Cooling parameters
Kuva 113-10 Valikon "Cooling" parametrit
Valikko: Special
Relay test
Screed
Program
Kuva 113-11 Valikon "Special" parametrit
Daikin RoCon+ HP
Daikin-ohjaus RoCon+ HP1
008.1447899_00 – 09/2019 – FI
Target flow cooling, start
Target flow cooling, max.
Start cooling outside temp.
Max. cooling outside temp.
Feed temperature lower limit
Feed temperature, cooling mode
Cooling setpoint correction
Screed drying
Screed program
Valikko: Information
Values
Kuva 113-12 Valikon "Information" parametrit
9 Sekoitinmoduuli
Average outside temperature
Mixer temperature, current
Mixer temperature, target
Mixer pump status
PWM mixer pump
Mixer valve status
Software no. B1/U1
Mixer software number
Käyttöohje
509