Error; Terminal; Statistics - Daikin RoCon+ HP1 ETSH16P30D Manuel D'utilisation

7.8

Error

[→ Main menu → Error]
Parameters Setting range
Min / Max
Emergency
Yes
No
Manual opera- Inactive
tion status
Active
Temperature, 20 – 80 °C
manual opera-
tion
Tab. 7-22 Parameter in the "Error" menu
7.9

Terminal

[→ Main menu → Terminal]
Parameters Setting range
Min / Max
Terminal ad- Off
dress
0 – 9
Bus scan Off
On
Controller
BM1/BE1 #X
Mixer #X
Tab. 7-23 Parameter in the "Terminal" menu
7.10

Statistics

[→ Main menu → Statistics]
Parameters Setting range
Min / Max
Energy HP, -
cooling
Energy HP, -
heating
Energy, hot -
water
Energy HP -
total
Electr. energy -
total
Ext. energy -
source, hot
water
Daikin RoCon+ HP
Daikin controller RoCon+ HP1
008.1447899_00 – 09/2019 – EN
Description
Emergency heating by backup heater or another external heat generator.
In the event of an error, emergency operation is automatically activated.
In the event of an error, emergency operation by manual activation only.
Activation of the fixed feed temperature control (for diagnostic purposes).
Required feed temperature for manual operation.
Description
Setting of the terminal ID of the control panel for system access. The set
value must be unique throughout the entire system. Confirmation of this
parameter with the rotary button effects a new initialisation of the controller.
All settings except "Off" authorise the user of the control panel to activate
the terminal function and thus to operate all RoCon system components
with a valid device ID.
No function
Controller checks which RoCon devices are connected in the system via
CAN bus lines. Detected devices are displayed in the menu [→ Main menu
→ Terminal] with type and data bus ID (e.g. MM#8 = mixer module with
bus ID 8).
With a detected device only: Activation switches to the heat generator with
the bus ID X (see Chap. 4.8, [Bus ID heat generator] parameter).
With a detected device only: Activation switches to the mixer module with
the bus ID X (see Chap. 4.8, [Heating circuit assignment] parameter).
Description
The amount of heat delivered by the heat pump for cooling operation is dis-
played in kWh (per month).
The amount of heat delivered by the heat pump for heating operation is
displayed in kWh (per month).
The amount of heat delivered by the heat pump for domestic hot water pre-
paration is displayed in kWh (per month).
The total amount of heat delivered by the heat pump is displayed in kWh
(per month).
The total electrical power consumed is displayed in kWh (per month).
The volume of heat of the additional heat generator for domestic hot water
preparation in kWh is displayed.
7 Parameter settings
Factory Incre- Access
setting ment
BE HF
- E
- E
50 °C - E
Factory Incre- Access
setting ment
BE HF
Off 1 N
Off - E
-
- E
Factory Incre- Access
setting ment
BE HF
- kWh S
- kWh S
- kWh
- kWh S
Operating Instructions
E
E
E
E
E
E
S
S
S
45