Mixer Module Parameter Settings - Daikin RoCon+ HP1 ETSH16P30D Manuel D'utilisation

9.3

Mixer module parameter settings

The parameters available for the mixer module are largely identical
to the parameter described in Chap.
parameters available for the mixer module.
Parameters Setting range
Min / Max
Min. mixer 10 – 100%
valve pump
Max. mixer 20 – 100%
valve pump
SlopeOffset 0 – 50 K
Mixer temper- 0 – 100 °C
ature, current
Mixer temper- 0 – 90 °C
ature, target
Mixer pump On
status
Off
PWM mixer 0 – 100%
pump
Mixer valve Neutral
status
Close
Open
Tab. 9-2 Parameters of the mixer module
Daikin RoCon+ HP
Daikin controller RoCon+ HP1
008.1447899_00 – 09/2019 – EN
7. Tab. 9-2 lists the additional
Description
[→ Main menu → System]
Minimum power of the pump in the mixer circuit.
[→ Main menu → System]
Maximum power of the pump in the mixer circuit.
[→ Main menu → Heating]
Setting of the slope offset of the feed target temperature on the Daikin
Altherma ETS(X/H) in comparison with the feed target temperature determ-
ined for the mixer circuit.
[→ Main menu → Information → Values]
Current feed temperature in the mixer circuit
[→ Main menu → Information → Values]
Current target feed temperature in the mixer circuit
[→ Main menu → Information → Values]
Current status of the mixer pump
[→ Main menu → Information → Values]
Current modulation of the mixer pump
[→ Main menu → Information → Values]
Current status of the mixer valve
9 Mixer module
Factory Incre- Access
setting ment
BE HF
30% 1% N E
100% 1% N E
5 K 1 K N E
- - S S
- - S S
- - S S
- - S S
- - S S
Operating Instructions
51