Maintenance - Ingersoll Rand 2340 Manuel De L'utilisateur

WHEN TRANSPORTING THE COMPRESSOR
- FOR GASOLINE ENGINE UNITS
CAUTION
• When transporting the compressor, shut off the Engine and
turn the fuel shut off valve to the off position. See Figure below.
• If the compressor is permanently mounted on a vehicle, shut
off the Engine and turn the fuel shut off valve to the off position
when the unit is not in use. See Figure below.
Gasoline Shut Off Valve (Shown in off position)
COMPRESSOR CONTROLS (GASOLINE ENGINE
COMPRESSORS)
CONSTANT SPEED CONTROL. This type of control applies to gasoline
engine compressors.
When the receiver tank pressure reaches the factory preset maximum
pressure, the unloader slows down the engine and the compressor
stops pumping. When the receiver tank pressure drops to the factory
preset minimum, the unloader resets, the engine returns to full speed,
and the compressor resumes pumping.
22607402 Rev.F
RELEASED 15/Mar/2018 20:10:54 GMT

MAINTENANCE

MAINTENANCE SCHEDULE
•
Check for oil leaks.
•
Check lubricant level. Fill as needed.
•
Drain receiver tank condensate (if
automatic draining device is not
provided). Open manual drain valve
and collect and dispose of condensate
accordingly.
•
Daily or Before
Check for unusual noise and vibration.
•
Each Operation
Ensure beltguards and covers are securely
in place.
•
Ensure engine (if supplied) is filled with
fuel and lubricant according to the
manufacturer's recommendations.
•
Ensure area around compressor is free
from rags, tools, debris, and flammable or
explosive materials.
•
Observe operation of safety/relief valves
while the compressor is running. Replace
safety/relief valves that do not operate
Weekly
freely.
•
Inspect air filter element(s). Clean if
necessary.
•
Inspect for air leaks. Squirt soapy water
around joints during compressor
operation and watch for bubbles.
•
Check tightness of screws and bolts.
Monthly
Tighten as needed.
•
Inspect drive belts. Adjust if necessary.
•
Clean exterior.
•
Change petroleum lubricant while
crankcase is warm.
3/500 * •
Drain compressor oil and clean oil sight
glass
•
Install maintenance pak
— or —
•
Change synthetic lubricant while
12/2000 *
crankcase is
•
warm.
•
Replace filter element.
* indicates months/operating hours, whichever occurs first.
EN-13