Preventative Maintenance Schedule - Ingersoll Rand PL-MANW Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Noted below are general maintenance guidelines, which must be followed and documented, this in accordance

with the Ingersoll Rand Warranty. It is based on an approximate Compressor usage of 30 hours per week. If your

particular application varies from this, please adjust accordingly.

When servicing the Air Compressor, shut off all power to the Unit, and drain the Tank

of air pressure. Always re-install the Beltguard after adjusting the Belts or Pulleys.

Insist on Genuine

Ingersoll Rand parts and

kits when maintaining

your Compressor Unit

and Pump.

Drain moisture from Air Receiver

Check oil level and top up as required

Clean Air Filter

Check Belt Tension

Check Safety Valves

Check that Unit unloads when shutting down

Clean and/or blow dust/dirt off Unit

Replace Air Filter

Replace Oil (synthetic)

Check lubrication of Motor

Inspect Valve Assemblies in Cylinder Head(s)

Replace Check Valve

Inspect Pressure Gauge

Replace Belts

Replace Valve Discs and Springs

Replace CPR Unloader Kit

Replace Pressure Switch

Replace Safety Valves on Pump and Tank

Replace Pressure Gauge

Notes:

1. Air Filters are available separately or in a Maintenance Kit. Consult your Pump bulletin.

2. Synthetic Oil is available separately or in a Maintenance Kit. Consult your Pump bulletin.

3. Belts are available through your local Ingersoll Rand Distributor.

4. Valve Discs and Springs are available separately or in a Kit. Consult your Pump bulletin.

5. The CPR Unloader Assembly and Kit is noted in your Pump bulletin.