Ingersoll Rand PL-MANW Mode D'emploi page 8

Motors.
Ensure that the voltage on your site is reflected on the
Motor nameplate, +/- 10%. In the case of 208 volts 3
phase electrics, the Unit must be 200 volts.
For single phase Motors, the voltage variance is 230
volts +/- 10%. A 208 volt power supply requires a
transformer to increase the voltage to 230 volts.
Use of an incorrect Motor for your particular
building service will result in premature Motor
failure, something not covered by the Ingersoll-
Rand or Motor manufacturers Warranty.
The Warranty that exists on the Electric Motor is that of
the original Motor manufacturer. In the event of a Motor
failure, contact your Ingersoll-Rand Distributor or
Service Centre for the location of the nearest
authorized Motor Service Centre.
Pump Rotation.
The Compressor is to be wired in a manner that
the rotation of the Pumps Flywheel causes the air
to be blown from the Beltguard forward over the
Pump. This, coupled with the unobstructed area
behind the Beltguard of 18" (0.5 m) minimum,
allows the Pump to cool properly.
Installation – Electrical (cont'd)
When facing the Compressor
(as shown at right), the
Flywheel must rotate in a
clockwise direction.
- 8 -
Why Hire a Licensed Electrician?
To ensure that your new Ingersoll-Rand Unit works as
designed and required, you must ensure that it is
correctly wired to your building service. It is the
responsibility of your Licensed Electrician to ensure
that:
 The Unit you purchased is suitable for your
particular buildings electrical service.
 Protective devices such as Magnetic Starters,
Fused Disconnects, etc have been sized and
installed correctly.
 Any electrical accessories purchased with your
Compressor have been installed and wired
correctly.
 The wiring of the Unit meets with all applicable
codes and regulations.
 When completed, the Unit works in both a safe
and correct manner.
Failure of the Compressor Unit due to an incorrect
electrical installation is not covered by the
manufacturer's warranty.
PL-MANW
Rev.B, Nov'20