Replacing Worn Parts; Important Warnings - Esmach NSE 30 Notice D'utilisation Et De Maintenance

SECTION B – POINT 7

REPLACING WORN PARTS

For reasons of safety it is essential to read and observe the IMPORTANT WARNINGS given
below before carrying out any work.

IMPORTANT WARNINGS

These operations must be performed by specialist expert personnel provided by the manufac-
turer or authorised qualified service centres.
Before performing any operation, remove the plug from the electrical power supply socket
interlocked with switch.
SECTION C – POINT 1
EMERGENCIES
If the machine is used correctly, emergencies cannot occur during operation or during clean-
ing and maintenance on condition that the latter are performed according to the instructions
provided in this manual.
In the event of imminent mechanical danger, press the emergency button and immediately
remove the plug from the current socket interlocked with switch. This must be followed by
identification of the failure or fault that caused the danger and restoring of machine operation
and protections. If necessary, request the assistance of the manufacturer's technical support
service or competent personnel.
If current leakage is found upon contact with metal parts of the machine, immediately re-
move the plug from the current socket, interlocked with switch, and call an electrician or the
manufacturer's technical support service.
SECTION C – POINT 2
DECOMMISSIONING – SCRAPPING
DECOMMISSIONING
If the machine has to be temporarily decommissioned for any reason, it must be unplugged
from the socket, interlocked with switch, cleaned as described in Section B, point 5 and cov-
ered to protect it from dust.
For re-commissioning, follow the commissioning instructions (see Section B, point 3).
SCRAPPING
At the end of its working life, the machine must be removed and withdrawn by the manufac-
turer or dealer. If the user wishes to perform scrapping himself, he should remember that
various materials are involved such as metals of various types, rubber, plastic, oil etc.
which must be disposed of in compliance with regulations for industrial and special waste,
i.e. by delivering the above materials, suitably selected, to specialist environment-friendly
disposal firms.
51