Esmach NSE 30 Notice D'utilisation Et De Maintenance page 37

Once a day:
Check the efficiency of the protections and safety devices by operating and inspecting them.
MAINTENANCE TO BE PERFORMED BY SERVICE PERSONNEL AUTHORISED BY THE MANUFAC-
TURER
Due to their delicate and complex nature, these operations and checks must be performed by
the manufacturer or qualified/specialist personnel.
Once a month:
Check the efficiency of the safety devices
Check the condition and positioning of the rollers or bowl guide sliding blocks
Once every six months:
Adjust the drive belt tension (instructions and figure below)
Check operation of the bowl
Check the electrical equipment
Check that the tool is correctly fixed
Lubricate the bearings
When necessary
Replace worn parts and/or broken elements, check and adjust the protections and safety de-
vices. The power supply cable must be replaced if the outer insulation is damaged.
Once a year
Perform general checks on the condition and efficiency of the machine, the protections and
safety devices.
Replace worn parts and/or broken elements if necessary.
Perform electrical tests to check the electrical insulation and continuity tests on the protection
circuit.
Caution: original parts must be used when replacing components.
CAUTION!
Cut off the electrical power supply before carrying out work
on any electrical component
or on the control panel.
41