Automatic Operation - Esmach NSE 30 Notice D'utilisation Et De Maintenance

Instruction for use and maintenance
Spiral mixer with fixed bowl
cycle;
The START button can be pressed also during operation of the machine in 1
case, if the minimum time in 1
If the stop has occurred with the machine in 2
by pressing the "start" key it is possible to continue operation: the machine restarts in 1
speed for the duration of the minimum 1
nd
matically to 2 speed (in this case the 1
display blinks until the 1
2 nd speed, the time increments and the display stops blinking.
If the "stop" key is pressed only once, the display-timers lock. If the stop key is pressed a
second time, the displays go to zero and it is possible to start a new cycle.
If the maximum time of 99'5(9)" is reached, the machine stops.

AUTOMATIC OPERATION

The "automatic cycle" key is enabled exclusively with the machine at a standstill, not in the
work cycle (i.e. at the end of an automatic cycle or after interrupting a manual cycle by
pressing the "stop" key twice).
When the "automatic cycle" key is pressed, the red led comes on and the two displays show
the operating times set in the last automatic work cycle (the first time the machine is used,
the following default values are set by Esmach: 5' in first speed, 8' in second speed).
These values can be modified via the "up" and "down" keys (the increment/decrement is 15"
up to 9'59" and 1' over 9'59"; if pressed for longer than 3s the scroll speed increases).
If the machine is provided with stainless steel grille bowl-protection it will not be possible to
set an operating time in first speed below 2' (minimum time in first speed = 2').
If the machine is provided with bowl-protection with ABS closed cover, it will not be possible
to set an operating time in first speed below 15" (minimum time in first speed = 15").
When the "start" key is pressed, the automatic cycle starts: the machine starts in first speed
and the display indicates the remaining operating time (decremental).
With the machine operating in first speed the "bowl-inversion" command is enabled.
When the related key is pressed, the red led comes on, the bowl stops and after a pause of
1.5s the machine inverts the movement of the bowl. This interval is not calculated by the
timer. The same thing happens when the key is pressed again and the inversion is de-
activated).
The first speed display shows the remaining time.
Whenever the "bowl-inversion" key is pressed, the first speed timer is temporarily locked for
the time indicated above (1.5s).
Once the time in first speed has elapsed, the machine switches automatically to second
speed: the first speed display remains set to zero while the second speed display begins to
decrement.
During operation of the machine it is possible to modify the 1
following limits:
minimum time in 1
be zero-set but not otherwise;
st nd
the 1 and 2 speed time cannot be modified simultaneously.
The modifications made during operation are not stored.
When the "stop" key is pressed, the machine stops and the display-timers lock at the time
28
st
speed has not yet elapsed, the 2
st
speed minimum time is reached). When the machine switches to
st
speed, i.e. if the min. time has already elapsed, the 1
nd
speed:
st
speed time (2 seconds) and then switches auto-
st
speed display-timer increments while the 2
st speed. In this
nd
speed display will blink.
st nd
and 2 speed times with the
st
speed time can
st
nd
speed