Esmach NSE 30 Notice D'utilisation Et De Maintenance page 26

Instruction for use and maintenance
Spiral mixer with fixed bowl
PROGRAMMING
Key 9 "PRG programming" is enabled exclusively with the machine at a standstill, not in the
work cycle (i.e. at the end of an automatic cycle or after interrupting a manual cycle by
pressing the "stop" key twice).
To enter "program-mode", press the "PRG programming" key for at least 3s: the related red
led will come on and the display will blink.
In this condition it is possible to set the 1
keys. To store these times the PRG key must be pressed again for 3s; the led will go out and
the program display will stop blinking.
If you enter programming, modify the times and then do not press any key, after 30s the
program display will stop blinking, the PRG key led will go out and the times will not be
stored.
It is possible to use 10 programs (from 0 to 9).
By pressing the "PRG programming" key several times, it is possible to scroll the 10 programs
on the related display (the display-timers will consequently show the related stored times).
When the number corresponding to the required program is displayed, it is possible to start
the automatic operation cycle by pressing the "start" key.
If key 9 "PRG programming" is pressed for less than 3s, you go on to the next program (if the
start, stop or automatic cycle keys are pressed in this phase or if the operator does not touch
any key for 30s); the modified times are not stored in memory (the program-display stops
blinking) and you return to the "program-mode".
To quit the "program-mode", press the "PRG programming" key for at least 3s: the related
red led will go out.
PROGRAM "0"
Unlike the other programs, program "0" allows you to set the times and store them without
having to press key 9 PRG for 3s. The times can be stored in program "0" with the same logic
as programs 1 to 9.
The times can be modified even when the machine is operating but those set before the
START remain stored.
BOWL-IMPULSES" COMMAND
This command is not enabled on machines with one single motor (e.g. NSE 30 – NSE 45 –
SPIRAL 50 – SPIRAL 70).
With the machine at a standstill, not in the work cycle (i.e. at the end of an automatic cycle
or after interrupting a manual cycle by pressing the "stop" key twice) and the bowl protection
open, impulse rotation of the bowl can be commanded by pressing key 13 "bowl inversion-
impulses".
"PARAMETER SETTING"
To access the "parameter setting" configuration as below, the emergency button must not be
pressed, the automatic key led must be off and the machine must not be operating. The dis-
plays must show 1
Simultaneously press the 4 buttons + / - for four seconds.
The parameters are selected via keys + / - on the left of the panel.
The parameter is enabled or disabled via keys + / - on the right of the panel.
"INC" parameter programming = bowl rotation (clockwise/anticlockwise)
ON = active
OFF = not active *
* default value for NSE 30 and SPIRAL 50/70E.
When the "INC" parameter is deactivated, the bowl output relay is not enabled if the bowl in-
version key (13) is pressed. The related led remains off.
30
st nd
-2 speed times "ooo ooo".
st nd
and 2 speed times by pressing the UP – DOWN