Esmach NSE 30 Notice D'utilisation Et De Maintenance page 25

remaining up to that point.
When the machine is stopped in 1
speed from the moment when it was interrupted until it completes at least the minimum time
(2 seconds or 2 minutes).
Once the minimum operating time in 1
st
the 1 speed display you can set the time up to zero and switch to 2
remaining time in 1
If the "emergency button" is pressed, the machine stops and the display-timers show a code
that corresponds to the message "emergency pressed" ("---" "---").
When the emergency button is released, the display-timers show the time remaining up to
that moment.
When the bowl-protection is raised with the machine operating, the machine stops and the
display-timers show the time remaining up to that moment in blinking mode. When the pro-
tection is closed, the display-timers show the time remaining up to that moment (in continu-
ous non-intermittent mode).
In these last three conditions, since the timer that measures the 1
set to zero, we can have the following situations:
If the stop has occurred with the machine in 1
by pressing the "start" key it is possible to continue operation; the machine restarts in 1
speed (in this case the display-timers do not set to zero but continue to decrement the time).
By pressing the "stop" key, the display-timers return to the initial values and it is possible to
start a new cycle.
If the stop has occurred with the machine in 2
by pressing the "start" button it is possible to continue operation: the machine restarts in 1
speed for the duration of the 1
display-timer is updated to the minimum operating time) and then switches automatically to
nd
2 speed (once the minimum time in 1
speed display time);
At the end of the cycle, the mixing times are reset on the displays.
If the START button is pressed within 60 seconds from the end of the cycle, the machine re-
st
starts in 1 speed and the time can be modified (via the "down" button below the 1
display) up to zero. If the 1
The second speed time can be modified as required (up to zero).
when the "stop" key is pressed, the display-timers go to zero and it is possible to start a new
cycle.
During the last 60s of operation in second speed (the machine signals the beginning of this
phase by emitting an acoustic signal) the 2
blinking mode (0.5s "on", 0.5s "off").
Once the time in second speed has elapsed, the machine automatically stops and an acoustic
signal sounds for 5s.
After the end of cycle acoustic signal, the display-timers show the initial values.
By pressing the "stop" key or the emergency button before the end of the acoustic signal, the
acoustic signal stops and the display-timers show the initial values.
In this condition, by pressing the "start" button, a new automatic cycle is started.
At the end of the cycle, after re-set of the times on the displays, if the 1
time can be displayed (2 minutes / 15 seconds). The time can be decreased up to zero only after pressing the START
button.
st
speed, when restarted, it will resume operation in 1
st
speed after which the machine automatically switches to 2nd speed.
st
speed minimum time (2 seconds) (in this case the 1
st
speed time is set to zero, it is possible to switch to 2
st
speed has been completed, via the "down" key below
st
speed:
nd
speed:
st
speed has elapsed, it resumes decreasing the 2
nd
speed display-timer shows the time remaining in
nd
speed, or complete the
st
speed minimum time has
speed time is decreased, the minimum
st
st
st
st
st
speed
nd
st
speed
nd
speed.
29