Emergency Situations - Esmach NSE 30 Notice D'utilisation Et De Maintenance

Instruction for use and maintenance
Spiral mixer with fixed bowl
MACHINE START-UP AND WORK CYCLE
NSE 60M—NSE 80M—NSE 100 M -NSE 130 M – NSE 160 M – NSE 200M - SPIRAL
80A—SPIRAL 110A—SPIRAL 150A—SPIRAL 200A – SPIRAL 300A
(with electromechanical control panel)
Preliminary operation
Set the mixing time in 1
automatically after the minimum operating time in 1
6).
st
1 operation
After filling the bowl with the ingredients, lower the bowl protection.
nd
2 operation
Turn the master switch "1" to position "I". The voltage pilot light "4" will come on.
rd
3 operation
Use the selector 5 to enable or disable operation of the machine in automatic cycle. With the
selector in position "1" the machine operates in 1
machine operates in 2
the standards (see Sec. A point 5); with the selector in the "automatic cycle" position, the
machine operates in automatic cycle according to the times set on the two timers.
th
4 operation
Press the START button "6". In this phase the spiral arm should rotate in the direction indi-
cated by the arrow. If not, press the STOP button "7", make sure you have set the external
power supply switch to "0" and invert the two wires R and S (see figure no. 29).
st
In 1 speed it is also possible to rotate the bowl in the opposite direction; simply set the in-
verter "9" to the right or left.
If the bowl protection is lifted during the work cycle, the machine stops and the cycle times
remain stored.
To restore the work cycle, lower the bowl protection and press the START button "6": the cy-
cle resumes from the moment at which it was interrupted with operation in 1
time established by the standards.
The rotation button "8" on the control panel permits rotation of the bowl with the grille raised
in order to facilitate extraction of the mixture.
If the STOP-EMERGENCY button "7" is pressed, the machine stops and the timers reset to the
initial value. At the end of work, reset the master switch to position "0".
Caution: never fill the bowl beyond the capacity indicated by the manufacturer as this can
seriously damage the mechanical transmission. Never invert the bowl rotation direction with-
out first ascertaining that the bowl has stopped. The company accepts no liability for any
damage caused by failure to observe this precaution.

Emergency situations

If operator safety is endangered by the moving parts of the machine (tool, bowl, drive ele-
ments), the machine must be stopped as quickly as possible in one of the following ways:
- by setting the master switch to "0"
- by setting the interlocked power socket switch to "0"
- by pressing the EMERGENCY button "7".
34
st nd
and 2 speed via the timers. Switching to the 2
nd
speed after starting in 1
st speed has elapsed (see Section A, point
st
speed; with the selector in position "2" the
st
speed for the minimum time established by
nd
speed occurs
st
speed for the