Emergency Situations - Esmach NSE 30 Notice D'utilisation Et De Maintenance

Instruction for use and maintenance
Spiral mixer with fixed bowl
MACHINE START-UP AND WORK CYCLE
NSE 30M – NSE 45M – SPIRAL 50A – SPIRAL 70A
(with electromechanical panel)
Preliminary operation
Set the mixing time in 1
automatically after the minimum operating time in 1
6).
st
1 operation
After filling the bowl with the ingredients, lower the bowl protection.
2 nd operation
Press the master switch key "1" ON, on the right side of the machine. The voltage pilot light
"4" will come on.
rd
3 operation
Use the selector 5 to enable or disable operation of the machine in automatic cycle. With the
selector in position "1" the machine operates in 1
machine operates in 2
the standards (see Sec. A point 5); with the selector in the "automatic cycle" position the ma-
chine operates in automatic cycle according to the times set on the two timers.
th
4 operation
Press the START button "6". In this phase the bowl should rotate in the direction indicated by
the arrow on the bowl. If not, press the STOP button "7", remove the plug from the socket,
interlocked with switch, and invert two phase wires (see figure no. 26, detail A-B).
If the bowl protection is lifted during the work cycle, the times set on the timers remain
stored.
To restore the work cycle, lower the bowl protection and press the START button "6": the cy-
cle resumes from the moment at which it was interrupted with operation in 1
time established by the standards.
If the STOP-EMERGENCY button "7" is pressed, the machine stops and the timers reset to the
initial value.
At the end of work, press the "Ø" key on the master switch.
Caution: never fill the bowl beyond the capacity indicated by the manufacturer as this can
seriously damage the mechanical transmission. The company accepts no liability for any dam-
age caused by failure to observe this precaution .

Emergency situations

If operator safety is endangered by the moving parts of the machine (tool, bowl, drive ele-
ments), the machine must be stopped as quickly as possible in one of the following ways:
- by cutting off the electrical power supply by pressing the "Ø" key on the master switch "1" -
by rotating the interlocked power socket switch to "Ø"
- by pressing the EMERGENCY button "7".
32
st and 2 nd speed via the timers. Switching to the 2
nd speed after starting in 1
st
speed has elapsed (see Section A, point
st
speed; with the selector in position "2" the
st speed for the minimum time established by
nd speed occurs
st
speed for the