Automatic Operation - Esmach SPI 160 A hybrid Notice D'utilisation Et De Maintenance

Instruction for use and maintenance
Spiral mixer with removable bowl SPI 160-300 A HYBRID
If the stop key is pressed, the machine stops and the display-timers lock at the time reached up
to that moment.
If the "emergency button" is pressed, the machine stops and the display-timers show a code
that corresponds to the message "emergency pressed" (e.g. "---" "---").
When the mushroom-headed button is released, the display-timers show the time reached up to
that moment.
Opening the machine protection, the machine will stop and the display-timers will show the time
reached up to that moment, in blinking mode.
When the protection is closed, the display-timers show the time reached up to that moment (in
continuous non-intermittent mode).
In these last three conditions, since the timer that measures the 1
set to zero, we can have the following situations:
If the stop has occurred with the machine in 1
At the next start-up, it will resume operation in 1
ted
until it completes at least the minimum time (2 seconds or 2 minutes).
Once the minimum operating time in 1
by pressing the START button.
When the "stop" key is pressed, the display-timers go to zero and it is possible to start a new
cycle;
The START button can be pressed also during operation of the machine in 1
if the minimum time in 1
If the stop has occurred with the machine in 2
by pressing the "start" key it is possible to continue operation: the machine restarts in 1
for the duration of the minimum 1
2 speed (in this case the 1
nd
until the 1 speed minimum time is reached). When the machine switches to 2
st
increments and the display stops blinking.
If the "stop" key is pressed only once, the display-timers lock. If the stop key is pressed a se-
cond
time, the displays go to zero and it is possible to start a new cycle.
If the maximum time of 99'5(9)" is reached, the machine stops.

AUTOMATIC OPERATION

The "automatic cycle" key is enabled exclusively with the machine at a standstill, not in the work
cycle (i.e. at the end of an automatic cycle or after interrupting a manual cycle by pressing the
"stop" key twice).
When the "automatic cycle" key is pressed, the red led comes on and the two displays show the
operating times set in the last automatic work cycle (the first time the machine is used,
the following default values are set by Esmach: 5' in first speed, 8' in second speed).
These values can be modified via the "up" and "down" keys (the increment/decrement is 15" up
to 9'59" and 1' over 9'59"; if pressed for longer than 3s the scroll speed increases).
If the machine is provided with stainless steel grille bowl-protection it will not be possible to set
an operating time in first speed below 2' (minimum time in first speed = 2').
If the machine is provided with bowl-protection with ABS closed cover, it will not be possible to
set an operating time in first speed below 15" (minimum time in first speed = 15").
36
speed has been completed, you can switch to 2
st
speed has not yet elapsed, the 2
st
speed time (2 seconds) and then switches automatically to
st
speed display-timer increments while the 2
st
speed:
st
speed from the moment when it was interrup-
st
speed display will blink.
nd
speed:
nd
speed minimum time has
st
speed. In this case,
st
speed display blinks
nd
speed, the time
nd
speed
nd
speed
st