Manual Operation - Esmach SPI 160 A hybrid Notice D'utilisation Et De Maintenance

WORKING CYCLE START – SPI Awith simplified control panel EB
Completely down stroke the machine head. On the machine keft side, the led near the emer-
gency
push button must be on.
After this operation it is possible to programm the cart and push START.

MANUAL OPERATION

If the emergency button is not pressed, the haed is downstroke, the automatic key led is not on
and the machine is not working, "ooo ooo" will be shown on the 1st-2nd speed time display. The
program display will show -.
In addition to the emergency button, only the following keys are active:
- "start"
- "stop"
- "bowl-inversion" (also during operation)
Keys 9 "PRG programming" and 11 "automatic cycle" are not enabled.
Time Keys 3-6 "up" and 4-7 "down" are neither active nor enabled.
Led 12 on the "automatic cycle" key and the led on the "PRG" key are off.
The two "display-timers" are set to zero (000 000).
When key 15 "start" is pressed, the machine starts at first speed.
The first speed display indicates the operating time (incremental): up to 9' and 50" it shows 2
digits for the seconds and 1 for the minutes; beyond this, it shows three digits for the minutes
(blinking dot to mark the seconds).
The program display 8 shows H.
With the machine operating only at first speed the "bowl-inversion" command is enabled.
When key 13 "bowl-inversion" is pressed, both the spiral arm and the bowl stop. After 1.5s the
movement is inverted. This interval is not calculated by the timer. (The same thing happens
when the key is pressed again and the inversion is de-activated).
The first speed display shows the time in incremental mode.
Whenever key 13 "bowl-inversion" is pressed, the first speed timer is temporarily blocked for the
time indicated above (1.5s).
If the bowl inversion function is enabled and the start key 15 is pressed twice, the machine ope-
rates
at minimum time at first speed with the bowl in reverse direction; it then operates for
1.5s with the bowl in normal direction and then switches to the 2
inversion function is automatically disabled. While the machine operates in 1
speed display blinks; this means that the machine switches automatically to 2
minimum operating time in 1
If the machine is operating in 1
to 2 speed. Reaching of the 1
nd
guaranteed.
The 1 speed display stops at the time reached; the 2
st
time (incremental).
If the machine is operating in 2
return to 1 speed (intermediate pause time between 2
st
If the start key 15 is pressed again, the machine operates at 2
All this is possible if the grille is not lifted or the stop key 16 is not pressed.
speed.
st
speed and button 15 "start" is pressed, the machine switches
st
speed minimum time (2 seconds or 2 minutes) must always be
st
speed and the start key 15 is pressed again, the machine will
nd
speed. In this case the bowl
nd
speed display indicates the operating
nd
and 1 time: 1.5s).
nd st
speed.
nd
English
speed, the second
st
speed after the
nd
35