Replacing Worn Parts; Decommissioning - Scrapping - Esmach SPI 160 A hybrid Notice D'utilisation Et De Maintenance

Instruction for use and maintenance
Spiral mixer with removable bowl SPI 160-300 A HYBRID
SECTION B - POINT 7

REPLACING WORN PARTS

For reasons of safety it is essential to read and observe the IMPORTANT WARNINGS given below
before carrying out any work.
IMPORTANT WARNINGS !
These operations must be performed by specialist expert personnel provided by the manufactu-
rer or authorised qualified service centres.
Before performing any operation, remove the plug from the electrical power supply socket inter-
locked with switch.
SECTION C - POINT 1
EMERGENCIES
If the machine is used correctly, emergencies cannot occur during operation or during cleaning
and maintenance on condition that the latter are performed according to the instructions provi-
ded in this manual.
In the event of imminent mechanical danger, press the emergency button and remove the plug
from the current socket interlocked with switch. This must be followed by identification of the
failure or fault that caused the danger and restoring of machine operation and protections. If
necessary, request the assistance of the manufacturer's technical support service or competent
personnel.
If current leakage is found upon contact with metal parts of the machine, immediately remove
the plug from the current socket, interlocked with switch, and call an electrician or the
manufacturer's technical support service.
SECTION C - POINT 2
DECOMMISSIONING – SCRAPPING
DECOMMISSIONING
If the machine has to be "temporarily" decommissioned for any reason, it must be unplugged
from the socket, interlocked with switch, cleaned as described in Section B, point 5 and covered
to protect it from dust.
For re-commissioning, follow the commissioning instructions (see Section B, point 3).
SCRAPPING
At the end of its working life, the machine must be removed and withdrawn by the manufacturer
or dealer. If the user wishes to perform scrapping himself, he should remember that various ma-
terials
are involved such as metals of various types, rubber, plastic, oil etc. which must be disposed
of in compliance with regulations for industrial and special waste, i.e. by delivering the
above materials, suitably selected, to specialist environment-friendly disposal firms.
54